Notice de montage MOOSfree



Notice de montage

1.
Remove Protection Foil:

Retirez les bandelettes de protection de la bande collante sur une longueur d’environ 50 cm.

remove releas-papers of butyl adhesive tape
2.
Stick MOOSfree®:

Appliquez MOOSfree® sur la première tuile et appuyez avec la main légèrement dessus. Ne jamais appliquer la bande sous tension.

attach MOOSfree on the first row of tiles below the ridge
3.
Roll over MOOSfree®:

Parfaire l’application en appuyant avec un rouleau de tapissier d’une largeur de plus ou moins 4,5 cm.

roll over MOOSfree
4.
Attach Completion Tape:

MOOSfree® may be shortened with scissors. An den Enden bzw. To cover joints and ends, install a strip of Completion Tape. For this purpose, remove the seperating foil of the butyl side, position the strip and press it down firmly by hand.

copper discharges ions to clean the roof of moss
5.
Mount MOOSfree® 30:

For a "perfect solution" MOOSfree® 30 may be installed additionally on the ridge or below windows using the procedure mentioned above. The installation sketch gives you further advice.

MOOSfree 30 keeps the ridge free of moss and lichens
6.
Finish Installation:

Check again, if every end or joint of the Moss Removal Tape is covered with a strip of Completion Tape. Thereby MOOSfree® will be optimally protected from sliding snow.

After mounting MOOSfree keeps the roof clean for many years
7.
Lightning Protection:

If the roof has a lightning protection system, the entire copper strip must be connected to the lightning protection rod. Special adapters made of copper, which are available as an accessory, have to be screwed every 2 m over the entire length. This procedure is not necessary for MOOSfree® 30 that has been mounted on the ridge.

CoTexx ISO 9001-2015 zertifiziert
Nous serons heureux de répondre à vos questions
téléphone: +49 8259 8287-81
info@moosfree.com